Everblades® Article Page

Everblades® Heated Windshield Wiper Blades for cars, trucks and busses.

Proven effective for safer winter driving since 1986!

W.N. Miller Company, Inc.

EVERBLADES® Heated Windshield Wiper REFILLS

INSTALLATION INSTRUCTIONS

WARNING!

Bending or twisting any portion of the blades may cause damage and poor wiping.

Keep wires from sharp edges in all steps.

• 1.      Remove black ties from the wiper blade holder by cutting them.

• 2.      Unplug wire connector plugs (one on each end of individual blade = 4 connectors)

• a.      Pull the wire connectors apart using one hand on both ends of the connector.

• v    You may wish to use pliers if this is difficult.

• 3.      Squeeze the end of the clip (found at one end of the blade) in order to allow the clip to be pulled straight off.

• 4.      Remove old blade and metal strip.

• 5.      Insert the metal strip on the NEW blade onto the blade holder until the clip SNAPS. 
• a.       Do this by sliding it onto one end of the blade holder and working it through all the claws that hold the metal strip in place.
• b.      The refill should not pull off once the clip SNAPS.

• 6.      Reconnect each of the 4 wire connectors (two per wiper).

• 7.      Use the black ties (supplied with refills) to secure the new wiper blade without any loops in the wire.

CAUTION:  Do NOT restrict wire or the blade-action by pulling the wire taught.

• 8.      Turn wiper heater switch ON to make sure blades heat. 
• a.      If they DON’T heat – recheck your connections at all points.
• ·        If no heat in a few minutes, check fuses and connections.
• ·        Make sure both grounds are GOOD.
• b.      If they DO heat – you have been successful!
• c.      You could sing or hum “I Can See Clearly Now” by Johnny Nash!}

Do call us if you have any questions or problems.

Everblades®  "The Hot Ones!"

A proven produce since 1986.

W.N. Miller Company, Inc.

1-800-746-0428

www.everblades.com

Manufactured in the Upper Peninsula of Michigan, USA